Songlivo

How to tune a banjo: open G (g D G B D), step by step

6 min read

Standard tuning for a 5-string banjo, from the 5th string to the 1st, is g D G B D. Strum the open strings together and you hear a G major chord, which is why it is called “open G”. What sets the banjo apart is the 5th string: it is a short string that starts halfway up the neck and gives one of the highest notes, not a low one. This guide covers the notes, tuning with and without a tuner, the other common tunings and why a banjo drifts out of tune.

Hit a term you don’t know? Music terms glossary

Standard tuning: open G (g D G B D)

StringOn the tunerNoteFrequency
5 (short string)G4G (high)392.00 Hz
4D3D (lowest string)146.83 Hz
3G3G196.00 Hz
2B3B246.94 Hz
1D4D293.66 Hz
5-string banjo, open G, A = 440 Hz. Tuners show the note with an octave number: G4 is the G above middle C on a piano.

The lower-case “g” marks that the 5th string sits an octave above the other G. Its tuning peg is on the side of the neck, level with the 5th fret, and the string starts there. The thumb plays it as a constantly repeated note, a drone, and that is where the banjo's bright, rolling sound comes from.

With a tuner, step by step

  1. Put the tuner in chromatic mode. Guitar mode expects E A D G B E and can misread the banjo's D and high G strings.
  2. Play the 4th string (D) open and watch the display. If the needle is on the flat side, tighten the peg; if it is sharp, loosen a little first and then tighten up to the note.
  3. Repeat for the 3rd string (G), the 2nd (B) and the 1st (D).
  4. Tune the 5th string (G4) last. Some tuners show it as a G an octave lower; if the note name is right and the needle is centred, it is in tune.
  5. Check them all once more. The banjo's body is a drum head, so tightening one string shifts the others slightly.

A banjo is loud and sharp, so a phone microphone hears the note even in a noisy room. When the whole band is playing, a clip-on tuner is still more reliable, because it listens to the vibration of the body.

Without a tuner: tuning by ear

Get the 4th string (D) right from a reference: the D on a piano, or the 4th string of a guitar in tune (an open guitar 4th string is also D3). Then tune the banjo to itself:

  1. Set the 4th string (D) to the reference.
  2. Fret the 4th string at the 5th fret: that is G. Match the open 3rd string to it.
  3. Fret the 3rd string at the 4th fret: that is B. Match the open 2nd string to it.
  4. Fret the 2nd string at the 3rd fret: that is D. Match the open 1st string to it.
  5. Fret the 1st string at the 5th fret: that is high G. Match the open 5th string to it.

When two notes are close but not equal, you hear a wavering beat; as you turn the peg the beat slows, and when it disappears the notes match. Final check: the open strings together should give a clean G major chord.

Double C, open D, tenor and 6-string banjo

TuningNotesUsed for
Double Cg C G C DTunes in C and F; from open G the 4th string drops a whole step to C and the 2nd rises a half step to C
Open Df♯ D F♯ A DTunes in D major
G modal (sawmill)g D G C DOld-time modal tunes; 2nd string up a half step
Tenor banjo (4 strings)C G D AJazz and Dixieland; tuned in fifths like a viola
Irish tenor (4 strings)G D A EIrish traditional music; an octave below a mandolin
6-string banjoE A D G B ESame as guitar; guitar chord shapes work directly
Other common tunings. Strings listed from 5 to 1 (4 to 1 on tenor).

When switching tunings, do not raise a string by more than a whole step; it may break or the bridge may shift. If you change tunings often, check the tuning again before the next song.

Why does a banjo go out of tune?

  • A floating bridge. A banjo bridge is not glued; string tension holds it in place. If it slides, the notes higher up the neck go off. If the 12th-fret note is not exactly an octave above the open string, the bridge has moved.
  • Head tension and humidity. The body is a stretched head; as humidity and temperature change, so does the head's tension, and the tuning with it.
  • The 5th-string peg. On most banjos the short string has a friction peg; if it is loose, the string slips flat.
  • New strings. Strings stretch during the first days; expect to retune often for a while.

Tuning a banjo with Songlivo

Songlivo's guided tuner supports the 5-string banjo; it is in the free version, shows no ads and needs no internet.

  1. Choose Banjo under Settings → Instrument. The tuner takes the number of strings and their notes from there, and chord diagrams are drawn for banjo.
  2. Open Settings → Tools → Tuner, tap Start and allow microphone access.
  3. The screen starts with the 5th string (G): “Play string 5”. Then it moves to the 4th (D), 3rd (G), 2nd (B) and 1st (D). Turn the peg as it says: “Tighten — flat” or “Loosen — sharp”.
  4. Once the string holds within ±10 cents for a moment, the screen says “In tune”, the phone vibrates and plays a short beep, and the tuner moves on by itself. At the end it shows “All strings in tune”.

The tuner uses standard open G with a reference of A = 440 Hz. There is no separate profile for double C, tenor or plectrum banjo. A 6-string banjo is tuned like a guitar, so choose Guitar.

Songlivo keeps your songs and setlists on the device, shows banjo chord diagrams and syncs the band over Wi-Fi or Bluetooth; the tuner and metronome are in the same app. For other stringed instruments see how to tune a mandolin; the rest of the setup is in the guide.

More guides